Vehicle: Concept Car

[bastiaan]

looks pretty good so far, what program did you use and what modeling technique?

[Vegeta]

I used 3D studio R3.1 on a 533mhx celeron 128MB w/ i810 chipset (yea, it is rough)

I used the tri-edge method for corners since I am smoothing with NURMS in meshsmooth. It takes a lot of work but it looks good.


Right now my mesh is a mess, the corners are so twisted and hard to tell what is what in some places where several seams intersect. But it doesn't look bad once smoothed.

[Vegeta]

Here is an update:

http://66.246.54.230/~tunamart/images/wip2.jpg

[Gremlin]

looks pretty good...lol, it also looks like an audi TT w/ subaru WRX body mods :surprised hee hee...
Keep up the good work,
Cheers!
:beer:

[sonix]

Very nice so far. There looks to be a small smoothing artifact though, where the headlight meets the wing just in front of the wheel arch.:thumbsup:

Sonix.

[Vegeta]

Yes, I am still trying to figure out how to fix that area around the headlight.. Seems like I spend hours just moving one vertex around to get results.

Next will be the windsheild and the rear window, and also I need to add a seam on the driver's side window where the door opens.

[wedge]

I dunno... this doesn't seem like the kind of car that would have a hood scoop.

[CGTalk Moderation]

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.