PDA

View Full Version : How do I correct this geometry?

kingoslo
02-28-2009, 05:29 PM
Hello my friends,

:D

For a while now, I've been working to model this car:

http://www.blogcdn.com/www.autoblog.com/media/2008/06/lp560-4_19.jpg

THis is how far I've come, but I am struggling with a detail by the wheel arch:

http://www.kingoslo.com/temp/mesh_overview.jpg

THe problem are three creases that appears. One from each corner, and one underneath the airvent:

http://www.kingoslo.com/temp/crease.jpg

This is what my wire looks like before mesh smooth:

http://www.kingoslo.com/temp/mesh.jpg



Here is the mesh as a *.max file for download: http://www.kingoslo.com/temp/crease_mesh.max (http://www.kingoslo.com/temp/crease_mesh.max)


Hoping somebody could show me the correct way to put my edges to smooth these creases out completly!

Thanks guys :D
GrogMcGee
02-28-2009, 09:12 PM
I do something like this:
http://lh6.ggpht.com/_kyuBN4GsaYo/SamocJcAb4I/AAAAAAAABXk/EOZgug7Nyik/s800/dragimage.jpg
kingoslo
03-01-2009, 12:41 PM
Thank you for your reply :thumbsup: I was worried nobody would bother to reply.

I tried what you said, but it gives me corners where the surface should be smooth. Hoping somebody could explain to be how to overcome this problem:

http://www.kingoslo.com/temp/meshsmooth.jpg

http://www.kingoslo.com/temp/mesh2.jpg