PDA

View Full Version : Try This

DigiLusionist
06-28-2003, 04:48 AM
Like Nanogator said, select the Ball tool (b key), then bring up the Numeric Panel (n key).

Set the Type to Tesselation, with no more than 3 Segments.

Lasso select the sphere. Bring up the Bevel tool (b key), and bevel
the side in (inset) with NO shift.

Then bevel with a negative shift (so the polys go inward.

Then bevel again with more inset and no shift.

Delete the highlighted polys.
DigiLusionist
06-28-2003, 04:51 AM
Oh, and during the last inset of the bevel, do a negative inset, so the polys stretch instead of shrink.
DigiLusionist
06-28-2003, 04:54 AM
Damn, I just realized this was supposed to be a reply to a thread about modeling a tesselated sphere object. It wasn't supposed to be not a new thread. Sorry, folks.
Captain
06-28-2003, 05:05 AM
Looks Awesome with Sub D's on!

-Captain
CGTalk Moderation
01-15-2006, 12:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.