PDA

View Full Version : Demo Reel 2008

Rodentthought
10-25-2008, 02:18 PM
Hi All,

I hve just completed my 3d animation course from Takshaa and I wouldbe happy to have all your C&C's on this.

This is the you link to my student reel 2008 :
http://in.youtube.com/watch?v=nvK4NnIJ0DQ

This is the link to the very 1st shot film done after I learnt the basics of Maya
(just in case if any of you haven't seen it before):
http://in.youtube.com/watch?v=TKVyIGLC_uk (http://in.youtube.com/watch?v=TKVyIGLC_uk)

-------------------------------------------------------------------------------------------
My Blog:http://www.rodentthought.blogspot.com/
Kev3D
10-26-2008, 01:39 PM
Hi, that's a great animation reel, good work. A lot of good work there, I liked the guy trying to get out of the glass. Is this Animation Mentor?

I reckon some bits could be left out of the reel, like for instance the bit where you show the guy doing the voice over.
Rodentthought
11-03-2008, 08:50 AM
Sorry Morlankey about the late reply, just had the time to comment back!

Well, thanks and this is not Animation Mentor. I studied at an Inistution called Takshaa (http://www.takshaa.com/)
in Bangalore, India.

Yep! you are right I am working on the secound half of that shot, need to update this.

Are you into animation?
opticalflavor
11-04-2008, 04:37 PM
Hey Deepak..
Firstly congratulations...those r good pieces of work tat u have put up.. it is impressive.
But 'once again'.... some things tat i would like to bring to ur notice..
1.The dialogue piece tat u have done looks very good when it comes to the body but if u look at the facials it looks a lil floaty.. particularly the eyebrow(the way it goes up and down).
2.In the tennis piece check the slide action in the end. there seems to be some problem there. does not look right to the eye.
Anyway congrats once again.. keep up the good work.
:)
CGTalk Moderation
11-04-2008, 04:37 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.