CGTalk - ++3dsMax Bird Wing Rig loop problem

View Full Version : ++3dsMax Bird Wing Rig loop problem

visualasylum

06-09-2003, 01:43 PM

I rigged a bird mesh, with the splineIKsolver, and made 2 sliders to control each of the wings. Then I animated 30 frames(1 cycle) of the wings, then went in trackview, selected OUT OF RANGES, and selected LOOP. The problem is that After the 30 frames, only one wing will animate, the other doesn't move.

I'm banging against the wall here. any help is greatly appreciated.
I must also say, that I have tried with one slider, and didn't work either. What am I missing?

Here's a preview: http://www.visualasylum.net/incoming/bird-rig.jpg

Thanks in advance,

G

Bobo

06-09-2003, 11:37 PM

Originally posted by visualasylum
I rigged a bird mesh, with the splineIKsolver, and made 2 sliders to control each of the wings. Then I animated 30 frames(1 cycle) of the wings, then went in trackview, selected OUT OF RANGES, and selected LOOP. The problem is that After the 30 frames, only one wing will animate, the other doesn't move.

Just a note that the problem has been solved on the Max Support Forum and obviously had to do with the length of the default wire controller range bars.

visualasylum

06-09-2003, 11:38 PM

THanks....got it.

G

CGTalk Moderation

01-15-2006, 09:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.