PDA

View Full Version : Projection Master normalize blemish


bisenberger
09-23-2008, 11:22 PM
When dropping an object with Double Sided, Deformation, and Normalized boxes checked and all other boxes unchecked. I run stokes with the Line stroke, Alpha 06, and Zadd (or Zsub) starting off of one side of the object to past the other side of the object with shift constraint. When I pick the object up there are blemishes where the stroke ran past the edge of the object. Any ideas as to what is causing this?

bisenberger
09-28-2008, 02:17 PM
The attached image should better show the process I'm using. Frame is turned on to show polygon orientation.

CGTalk Moderation
09-28-2008, 02:17 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.