Filling a glass...

[ThirdEye]

Use a Lathe Nurbs

[Creature]

Originally posted by Kirl
How can I easily fill a glass or bottle I made?

Put liquid in it :D

[derwolpertinger]

i guess you created the glass with lathe nurbs, so just duplicate the glass, and then cut off the upper and outer part of the spline and close the spline where the liquids surface is going to be. when you create the shader for the liquid make sure to enable the displacement channel and just add a plain white in there and set the offset to 0.01. that prevents ugly render artifacts appearing when 2 surfaces are exactly at the same coordinates.

[Kirl]

Thanks, I actually used Loft NURBS but now I heard your solutions I guess I can do something similar.

Thanks alot...!

[alienesque]

hi..dont forget the 'bump'around the edge though caused by ..i think its called 'surface tension'

[knight42]

<physics>It's the meniscus</physics>, which I think you get in the Olympics, too. *nods sagely*

J

[artemesia66]

which I think you get in the Olympics, too. *nods sagely*

ROTFL

[JIII]

isnt it possible to do this with boole?

[CGTalk Moderation]

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.