CGTalk - Need little help with HyperNURBS and little more...

View Full Version : Need little help with HyperNURBS and little more...

AutoBot2000

06-01-2003, 07:31 AM

I started a Tut on making a car with Nurbs and kinda hit a little bump. When i move one side of my model into the Symmerty object i get same model on the other side fine but then when i move up one more in the hypernurbs, doesnt come out the way i want it.

At the bottom center that is a curved coner, i dont want that. I want it to be as if there as nothing there just flat and even. See pic for what i mean.

Per-Anders

06-01-2003, 07:54 AM

the correct structure is

hypernurbs
|_symmetry object
|___mesh

then jsut make sure all the along teh centre are at 0. or yo ucan set the tolerance in the symmetry object to be higher, and then it will automatically weld the points together with a bigger gap, and that will get rid of the round corner.

AutoBot2000

06-01-2003, 08:13 PM

Thanks :thumbsup:

CGTalk Moderation

01-15-2006, 07:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.