PDA

View Full Version : noise position on stiky particles

f3derico
07-02-2008, 07:54 AM
I have particle around screen flying and then forming a logo. I've used find target and particles stik well on logo. But I need that after they formed the logo, particle continue moving a bit like a noise position. it's possible?
MarinPetkov
07-13-2008, 10:58 AM
You can add a Wind without Strenght but with increased values of the Turbulence & Frequency
PsychoSilence
07-15-2008, 09:23 PM
if BOX#1 is available i would use a LOCK/BOND operator in connection with a wind. Then set the Force Influence to an appropriate value below 100% to have a wiggle motion going on that is attached to the surface of your logo.

Other then that it smells like a BOX#3 solution should be considered...currently working on something similar to that actually. i might post a preview and workaround soon-ish.

here's an ancient tutorial i wrote that involves wiggle motion too:
http://www.cgarena.com/freestuff/tutorials/max/pflow_splines/index.html

with kind regards,
Anselm
CGTalk Moderation
07-15-2008, 09:23 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.