PDA

View Full Version : new orthographic view prob

kiri
05-13-2003, 01:24 PM
hey, i tried to set up an orthographic view to be from back instead of front... but for some reason it doesnt work.
i can see the view from the right angle, but half of my model is weirdly clipped.
i tried to change the clipping values, and even i tried to rotate my main front camera 180 degrees, but still happens.
i think maybe its because of an image plane i have attached to the camera??
or is there some setting i must change?
thanks
lostpencil
05-13-2003, 05:24 PM
Sounds like your image plane is clipping the model. Try moving the image plane (or put it on a layer and make it invisible) and see if that helps. If not, post a link to an image and we can see if there is something else that may be happening.
so_hi
05-14-2003, 11:36 AM
It maybe that your ortho camera is in your geometery.
Try showing that camera looking at where it is in a 3d view.
Remember to move it only on it's axis in which it is pointing.

Hope this helps.

E.
CGTalk Moderation
01-15-2006, 03:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.