fur problem

[madart]

Looking at your UV-layout, I think there are two things that you already now, but I'll mention them anyway.

Everything that is to be covered by fur has to be within the 0-1 square.

And to place the UV-layout in the same direction as the fur, which I think that you have already done. And make it as much as possible in one piece. Less seams that way.

But what I can see, is the area around the elbows, where there are a lot of thin polys. If you were to make them bigger in the UV-layout, then I think that the fur will spread out more in those areas.

There are no hairs on the edges of the character, if you were to smooth him, then you'll see that you'll get a much more even result.

Hope that this helps!

[finalmilk]

thank a lot i will try it

[CGTalk Moderation]

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.