PDA

View Full Version : pose/trax edt. prob


smileyPotato
04-23-2003, 04:02 AM
I'm trying to pose a character for a run animation.. ive got all the attr. needed in a character set. i position everything for the pose, highlight the character set and say create pose in the trax editor. it says "Result: run1" but no pose comes up. it creates a clip instead. (error listed below). is there something i'm not doing? thanks.

doCreatePoseArgList 2 { "run1" };
pose -name "run1" Squirrel;
// Error: Connection not made: 'animCurveTA97.apply' -> 'SquirrelClips1.clipEvalList[2].clipEval[6].clipEval_Raw'. Destination attribute must be writable. //
// Error: Connection not made: 'animCurveTA97.apply' -> 'SquirrelClips1.clipEvalList[2].clipEval[6].clipEval_Raw'. Destination attribute must be writable. //
// Result: run1 //
// Result: run1



-chris

dwalden74
04-23-2003, 11:01 AM
Not sure. You might just want to try and delete your character set and rebuild it, then try again. That should solve the prob.

:beer:
David

CGTalk Moderation
01-14-2006, 11:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.