jablinko
11-16-2007, 10:10 PM
just trying to figure out how spline dynamics think.
had a rig i thought was working ok, all of a sudden the spline is hanging a ways off of the attach point. i also have what seems to be a bad init state.
what steps do i need to do to free up the spline dynamics to move the end point in position, and be able to reset the attachpoint and not have to start all over.
what is the best way to free up the spline and move it into a nice initial state. i just feel like im getting better at the setup but when it breaks down, i have a hard time manipulating the thing.
not looking for a tutorial but any tips would be great
thanks
had a rig i thought was working ok, all of a sudden the spline is hanging a ways off of the attach point. i also have what seems to be a bad init state.
what steps do i need to do to free up the spline dynamics to move the end point in position, and be able to reset the attachpoint and not have to start all over.
what is the best way to free up the spline and move it into a nice initial state. i just feel like im getting better at the setup but when it breaks down, i have a hard time manipulating the thing.
not looking for a tutorial but any tips would be great
thanks