PDA

View Full Version : when extruding dimensions go wrong

fla
07-03-2007, 04:58 PM
Hi!

I've started with modeling work on an architecture project - simple ortogonal walls. But when extruding those walls somehow the dimensions dont match the ones I put in the Offset input - when i use Measure tools it shows compleatly different one.
Am I doing anything wrong? Never had problems with this till now (?)

regards,
matej
fla
07-03-2007, 05:29 PM
It had something to do with me scaling the plan before I've started to extrude - afterwards every point was scaled accordingly to scale ratio.

sorry for intrusion:)

regards
CGTalk Moderation
07-03-2007, 05:29 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.