PDA

View Full Version : mudbox to zb3

xsitar
05-21-2007, 02:13 AM
is there a way to import the lowest level and the highest level so i have the lower level and high level information in zb3 to continue on?

i wanna pick up in zb3 where i left in mudbox. but i fear the model will receive some more deformations (not just displacements) and thus it would be great if i had the lower levels somehow in zb3.

is it possible or is there any other way i could get it working in zb3?
jramauri
05-21-2007, 02:28 AM
You can go to the highest level of your model on Mudbox and then export it as an OBJ. Reimport this model within Zbrush and then on the Tool palete, on geometry section click in "Reconstruct subdiv". Go to the lower level and repeat these steps until you reach the desired level of division. If your geometry is well formed you won't have trouble.
CGTalk Moderation
05-21-2007, 02:28 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.