PDA

View Full Version : Problem in distribute curves of a vent in a smoothing model


SinoChoi
03-28-2007, 04:25 AM
Hi, I am using 3ds 8, this model is a polygon with turbosmooth.
When I get start to build a vent in this model, I had some problems of pinching when I smooth the model, but luckily I found the solution after I read the post of kirigoi, thanks for the useful imformation to solve my problems.

http://img.photobucket.com/albums/v466/sinochoi/01-10.jpg

this is before I use the new solution

http://img.photobucket.com/albums/v466/sinochoi/q04.jpg


http://img.photobucket.com/albums/v466/sinochoi/q05.jpg

And now I have a new question about distribute the curves of using the new solution. I am not sure if this way will work, but at last I get a better result after smoothing

http://img.photobucket.com/albums/v466/sinochoi/new_smooth.jpg


http://img.photobucket.com/albums/v466/sinochoi/new_smooth03.jpg

this is the upper vent

http://img.photobucket.com/albums/v466/sinochoi/new_smooth02.jpg

this is the lower one

http://img.photobucket.com/albums/v466/sinochoi/new_smooth03.jpg

I will be grateful if any suggestion and advices to improve this model, thank you !!

CGTalk Moderation
03-28-2007, 04:25 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.