PDA

View Full Version : Rig problems

Xenophobe
03-13-2007, 08:09 PM
Sometimes when I insert an IKHandle, point constrain or pole vector, the corresponding joints move out of place. Is there a way to stop this from happening?

Thanks...
Tornado7
03-15-2007, 11:28 AM
I can say to check maintain offset when you do a point constraint, but I don't why this happens when you create a ikhandle or pole vector...

I hope this can help
twedzel
03-17-2007, 12:07 AM
Set prefered angle
Xenophobe
03-17-2007, 12:10 AM
Thank you both!
CGTalk Moderation
03-17-2007, 12:10 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.