PDA

View Full Version : Is this wire wrong?


LunaticuMaster
02-09-2007, 07:13 PM
Is this wire wrong?

http://www.slibe.com/memberimage/b32760e0-wrong_or_right/

Is this kind od modeling wrong?If yes,why ? Causes any specific problems?

mech7
02-09-2007, 07:15 PM
Depends what you are going to use it for.. if you smooth it the big ngon will probably deform kinda weird.

Dogway
02-12-2007, 09:13 AM
If you leave it so, its no problem. But if you plan to smooth it, you should connect every vertex to get a good smoothing, and at last stage, clean again flat areas.

CGTalk Moderation
02-12-2007, 09:13 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.