CGTalk - welding vertices of two shapes in the same object

View Full Version : welding vertices of two shapes in the same object

Toxie

03-25-2002, 06:01 AM

I can always handle some of the most complicated things in the world but when it comes to the simple things I'm totally clueless ( you guys must be able to relate :) ) . My problem goes like this , I make two shapes then I convert them to splines I attach one of the shapes to the other then I try to wield the vertexes together but it will not work .... any suggestions.
Here is a picture attached below to clear up any confusion.

Chris

03-25-2002, 06:50 AM

Hope I'm understanding your problem alright, but I dont think a single vertice of a spline can share more than two line segments... Depending on what you are trying to acheive, what about just fusing them or converting the object to a mesh or poly then welding?

Toxie

03-25-2002, 06:58 AM

Thanks , what you said made perfect sense you understood me 100% , I was hoping that 1 spline vertex could be shared by multiple lines , oh well :( I guess I could try an alternative :)

CGTalk Moderation

01-13-2006, 03:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.