CGTalk - Bevel?

View Full Version : Bevel?

S3D

02-17-2003, 10:23 PM

Ok, there is one little thing which continues to have me stumped.

Lets say you create a cube then extrude the top straight up on Y axis (bear with me here ok? ), anyways then you selected one of the top front faces and applied a Bevel... this move effects not only that face but as well those directly around it... this is not a true bevel.

However if you were to extrude said face out a bit the scale it down, voila a true bevel... but this takes two procedures to do rather than but one......... hmmmmm

any takes on this?

puzzledpaul

02-17-2003, 10:34 PM

There might be something of interest here?

pp

http://pub33.ezboard.com/fnendowingsmiraifrm3.showMessage?topicID=363.topic

S3D

02-17-2003, 11:32 PM

Hey PP, thanks for the link :)

Man this is what forums is all about :thumbsup: :thumbsup:

CGTalk Moderation

01-14-2006, 02:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.