View Full Version : ATOS 3d scanning

02-12-2003, 07:25 PM
Is anyone out there familiar with the ATOS 3-d scanner? We recently obtained one here at the university I attend. I am part of an independent study to figure out how it works and how to scan objects with it. We are having quite a bit of trouble getting any meaningful data from this thing. The instruction manual we have is not the best, and I was just wondering if anyone knew of any place we could go for simple, step by step instructions on how to scan with this piece of equipment. Any other comments on the ATOS system in general would also be welcome. Thanks!

02-13-2003, 03:14 AM
Is it plugged in?

02-13-2003, 02:35 PM
Ha ha....

02-14-2003, 04:58 PM
Come on Folks. With all the talent/knowledge on this forum, there's got to be someone that knows something about the Atos scanner. Fill us in please.

02-14-2003, 05:01 PM
Can you not just call the manufacutrer. I'd think if anyone could help you it would be them.

02-14-2003, 05:16 PM
We have been working on this project for almost four weeks now. We have already attempted to contact the manufacturer but they don't wanna help us out, so we're looking for other people who may have experience with it.

02-14-2003, 06:47 PM
GOM has offices all over the world. Surely someone at one of these offices must be willing to help you guys out.


CGTalk Moderation
01-14-2006, 10:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.