moth3r
11-02-2006, 01:26 PM
Hi, guys i am new user to Rhino but i already done lot of stuff with it (moth3r.net).But right now i have really specific problem. Surface below is made by lofting. I selected all green lines and than i choose "tight" in lofting options. I have curves at first part of object wich are rotated so i can generate whole surface in one step. But every time surface generates error on part where curves are connected (up&down) in one point as u can see it on the bottom picture.
I recreted the problem in MOI (Moment of inspiration) another promising Nurbs program and then i end with perfect surface without problem i am mentioning. But again when i moved that new surface back to Rhino the problem on surface was visible again. In MOI that was not existing. I am sure because i used C4D with exported surface to polygons to render and check for errors.
Anyway thx for help!
http://img143.imageshack.us/img143/2702/rhinoej2.jpg
http://img182.imageshack.us/img182/1966/rhino2ni6.jpg
---
www.moth3r.net (http://www.moth3r.net)
I recreted the problem in MOI (Moment of inspiration) another promising Nurbs program and then i end with perfect surface without problem i am mentioning. But again when i moved that new surface back to Rhino the problem on surface was visible again. In MOI that was not existing. I am sure because i used C4D with exported surface to polygons to render and check for errors.
Anyway thx for help!
http://img143.imageshack.us/img143/2702/rhinoej2.jpg
http://img182.imageshack.us/img182/1966/rhino2ni6.jpg
---
www.moth3r.net (http://www.moth3r.net)