PDA

View Full Version : Mirai modeler trouble


robin
03-17-2002, 03:27 PM
Hi, i got a quick question for people that use Mirai 1

how can i make a mirror copy of this mesh so that everything done on the base object is automaticly reflected on the mirror copy (instances)


i tryed several times the mirror command but no luck, notting moves on the second half

thanks

Martin-K-
03-18-2002, 03:15 AM
im guessing you used the mirror.

try to use the virtual mirror instead.
by the way. read the manual. itll give you instructions on some of the preparation steps to have a solid VM.

read the getting started PDF.

and then for tutorials...read the Workbook PDF.

do not...SKIP out on the getting started manual. because it gives you lots of pointers on the interface. which IMO are very important later down the road.

robin
03-18-2002, 04:03 AM
virtual mirror works .....
i did the few first tutorials but was looking for this prompt ...

good Job !!!

CGTalk Moderation
01-13-2006, 03:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.