PDA

View Full Version : Adding detail to a curve


TheWriter
01-19-2003, 08:51 AM
Back to curve modeling. Assume a path was made, with bezier or spline. Everything is dory, until we realize we need more detail, such as an extra verticie or two in a section on that line curve. What is the best method to place an extra verticie into there?

wgreenlee1
01-19-2003, 09:28 AM
Construct>Sub-Divide>Add Points

TheWriter
01-19-2003, 09:46 AM
Ahh yes, finaly got it to work. Re-read the manual on that one. The reason why I didnt get it to work earlier, is I didn't know that even if the curve is alone in the layer, you still need to manualy select the entire curve in poly mode before you can do this.

Thanks, this will make my modeling a tad easier.

Fasty
01-19-2003, 09:46 AM
Now if only you could Knife a spline...

uncommongrafx
01-19-2003, 02:14 PM
You should go to Flay for knifeage to a spline; I believe I saw one there one day.
There are tools out there for that. This morn, unfortunately, I am a lazy fella... Good luck on your search.
Robert Wilson
UnCommon Grafx

Fasty
01-19-2003, 07:46 PM
Thanks, Robert. Although it would be nicer if Shift+k did all knifing.

CGTalk Moderation
01-14-2006, 05:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.