PDA

View Full Version : Image plane disapears in wireframe mode?

tiaka
05-11-2006, 11:04 PM
Hi there :)
Could someone please help me set up my image plane to work.
I have made a nurbs plane with a image applied to it and also i have put it onto a new layer and lock it. The only problem now is that when i go to view it in wire frame mode i lose the image plane. It comes back when i press key 6. But it would be nice to view my model in wireframe mode and have the image plane there also for referance.

Thanku for your help and ideas.
MM_Ghost_3D
05-11-2006, 11:09 PM
Why not just create a regular plane?
tiaka
05-11-2006, 11:55 PM
For some reason I can not use regular plane because when I zoom in for a close look at the vertices the regular plane skews and resizes. Have enabled radio button Image plane "fixed" . Still no go. So I have resorted to using a nurbs plane instead.
Thanks for your interest.
kingmango
05-12-2006, 02:39 AM
if the image plane is on the same plane as the orthogonal axis for depth at "0" it can sometimes get lost. Try setting it back a couple of units.

Er what I mean is if you are looking up and down X in say side view, then move the plane +2 or so in X.
CGTalk Moderation
05-12-2006, 02:39 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.