PDA

View Full Version : BMW 535i (1990) my own car WIP

escondar
03-23-2006, 04:38 PM
Slow going, need to make a virtual douple for my own car for an upcoming film.

I have an old bimmer. These blueprints are rough but I use a lot of photo references.

comments and crits welcome
AdamT
03-23-2006, 04:44 PM
It looks excellent so far. Keep it up!
escondar
03-24-2006, 03:46 PM
Rebuilding the frond end...
jcarey
03-24-2006, 06:30 PM
Looks good so far :)

I'm curious how you made the texture for the turn signals. I'm working on a car model also and can't figure out how to get the crasshatched look that you have in yours.
tonare
03-24-2006, 06:33 PM
Looking real good so far. I need to try setting my blueprints up like that one day.:)
escondar
03-24-2006, 08:11 PM
I used the attached texture (Quick photoshop hack job) but it is only in there as a temp texture. Eventualy I will do a proper glass treatment.
escondar
03-26-2006, 05:43 PM
back end work. Just temp light textures.
JIII
03-27-2006, 01:08 AM
good looking work man, I really like how clean that model looks. You will be able to take this very close to photo real in just a few days :-), nice work dude.

-JIII
AdamT
03-27-2006, 02:48 AM
Looking good. How about a wireframe?
escondar
03-27-2006, 01:19 PM
Wire frame. I also redid the head lights with glass. They don't quite look right. Either do the turn signals. Might have to start from scratch with the signals.
AdamT
03-27-2006, 01:20 PM
Wire frame. I also redid the head lights with glass. They don't quite look right. Either do the turn signals. Might have to start from scratch with the signals.
Nice and clean--good work!
escondar
03-27-2006, 11:17 PM
I did the rims and thought I'd render it under the sun to expose the exterior flaws before I did the last pass. I found a lot of them in the bright light (as you can see). Back to the drawing board.

In a couple of days I hope to move into the inside.
CGTalk Moderation
03-27-2006, 11:17 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.