PDA

View Full Version : Advise on Re:Vision Morph

Henry Anthony
02-27-2006, 08:43 PM
Hi everybody,

I need to morph many still images and am new to C4 and Re:Vision plugin. I am wondering if it would be possible to reuse the morph splines. For instance, I will morph image1, image2 and image3. I draw splines for image1 and image2 to morph. Will I need to draw splines again for image2 when I set up morph for image2 to image3 or can I somehow use splines from first morph setup?

Also, when I need to morph a new set of images, can I just swap out images and adjust splines or do I need to start again from scratch - new images, new splines. So maybe my question is "Can I set up a template for morphing different sets of images?"

Best regards,

Henry
neogeo51
02-28-2006, 09:09 AM
I would suggest to create one composite setup, duplicate that composite and replace the footage in the new composite. The morph splines could also be copy and pasted between the comps. Hope that helps.
Henry Anthony
02-28-2006, 12:11 PM
Thanks for the suggestion, neogeo51. I will give it a try.
Henry Anthony
03-07-2006, 08:00 PM
Julius,

I really did not understand your reply. Then I just started poking around and figured out what I needed. I reread your suggestion and now realize it was correct after all. Thanks so much.

Best regards,

Henry
Vympel
03-07-2006, 09:22 PM
Add the secondo moprh operator in the output of composite operator or nest the layers ( create a composite operator before the atual composite OP)
Henry Anthony
03-08-2006, 11:46 AM
Vympel,

I'm sure there is some validity in what you write although I don't understand it - yet. I will work on it.

Best regards,

Henry
CGTalk Moderation
03-08-2006, 11:46 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.