CGTalk - Camera shape??

matty2x4

02-09-2006, 01:00 AM

Hi all, I am wondering if someone could help me here?
I am tring to render an animation, I have done this a few times before no worries.
However this time when I do a single render it looks like what I want. But when I do a batch render it renders the whole sequence not looking like I want and gives it "file name_027.tif" etc... which is the name I want. But then it renders it ALL again looking how I want it but names it "file name__camerashape1027.tif" which is not the name I want.
I dont mind renumbering the second render to get what I want but rendering the whole thing twice to only use the second half of all the renders is out of the question.
Any ideas? what have I accidentaly turned on?
The only thing I can think is its an imported camera??
Please help.
Thanks
Matty2x4

MentaLDeFect

02-09-2006, 04:25 PM

Could it be possible that you have 2 renderable cameras in your scene?

matty2x4

02-11-2006, 09:31 PM

there is only one camera in the scene. although perspecive did have (renderable) after it in the list. But I may have found the answer, I think it had somting to do with 3-d motion blur. I have changed to 2-d and fiddled with a few other settings and its going properly now... go figure huh?

CGTalk Moderation

02-11-2006, 09:31 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.