edge probelm, for join blending

[Glyptic]

I can't read the copy on your image, so I'm *really* guessing here.

Have you tried to Explode then loosen your Absolute Tolerances (example from .001 to .01) then Select All>Join?
Sometimes a simple Explode, Select All, Join also works.
If you asking about singularities, that's probably not going to help. Those buggers are often caused by modeling issues, which can get complicated.
Maybe post a larger image, so I can see what's going on.
good luck,
glyptic

[saiko]

could u pls post a bigger Screen shot ?
Can't figure out what's happening there..


regards
saiko

[joker-like]

i hope it will be enough for checking

[JimCarruthers]

It would appear what you're talking aobut is one of the 'natural' edges of the surface, you can't remove that--and it's also a bad idea to try to adjust the surface to make the corner 'go away.' Without knowing exactly what you want to acheive, it's hard to say how you should proceed.

[saiko]

It would appear what you're talking aobut is one of the 'natural' edges of the surface, you can't remove that--and it's also a bad idea to try to adjust the surface to make the corner 'go away.' Without knowing exactly what you want to acheive, it's hard to say how you should proceed.

as jim said, could u please explain little more about what exactly u are trying to achive...

[joker-like]

thanks for ypur attention..i upload the file if you'ld see it, i think exactly you can understand what i want.the curves between the to surfaces i draw will be the connector the upper jaw to bottom.just connect them followed by the curves i draw.
tnx
http://us.f1.yahoofs.com/bc/1a98c6f1/bc/Friends/dino.zip?bfA86yDB7y05nv01

[saiko]

thanks for ypur attention..i upload the file if you'ld see it, i think exactly you can understand what i want.the curves between the to surfaces i draw will be the connector the upper jaw to bottom.just connect them followed by the curves i draw.
tnx
http://us.f1.yahoofs.com/bc/1a98c6f1/bc/Friends/dino.zip?bfA86yDB7y05nv01

but i can't access the file!
would u like to upload it to yousendit.com?


regards,
saiko

[CGTalk Moderation]

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.