PDA

View Full Version : Need some help with stitch plugin

minimi13
11-24-2002, 01:37 PM
hello

i have the digimation stitch plugin and i want to know how i can make some cloth that have two sides, because when you apply the garmentmaker modifier to a spline the cloth that you get always has one side that you can see through.

so when i want t make a cape (hope i typed it right) i always can see through one side...

So please can someone help me (i also send this question to digimation but they didn't give me an answer yet)...

THANKS A LOT

minimi13
Xaya
11-24-2002, 02:24 PM
the easiest solution would be,
that you switch on the "render 2 sides" button in
the renderoptions


or if you also want to see it in the viewport (in the viewports config)




Xaya :shrug:
minimi13
11-24-2002, 02:56 PM
damn i'm sooooo stupid...

i should have checked this option right from the beginning when i started 3ds max 5



THANK YOU VERY MUCH


minimi13
Iain McFadzen
11-25-2002, 10:25 AM
If you want the cloth to have actual physical thickness have a look at the free Solidify modifier plugin (www.maxplugins.de)
minimi13
11-25-2002, 10:59 AM
thanks for the link i already read about this plugin in the stitch help file

i will give it a try and see if it is better than converting the cloth to an editable mesh and extrude it a bit after the complete simulation

bye

minimi13
CGTalk Moderation
01-13-2006, 10:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.