CGTalk - EP Curve Question

BlissDD

11-17-2002, 02:57 AM

Hi All,

How do i insert an EP into a curve???...my prblem is i am using a 3-cubic EP line tool...but i need a few hard edges in the line at some stages....how do i go back after creation and insert EPs so that i can get the hard edge???

OR..

Is there a better way to do it??? ie: can i use liner EP lines as needed and then group all the curves into one single line???

Cheers :D

empleh

11-17-2002, 09:22 PM

Right click on the curve and from the little marking menu choose "curve point". Left click on the curve where you want to insert the EP. A yellow point should appear. Choose Edit Curves->Insert Knot. Now you should have a new EP where the yellow point was.

good luck
ww

BlissDD

11-17-2002, 09:24 PM

thanks dude :bounce:

CGTalk Moderation

01-13-2006, 09:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.