AlanMc
11-10-2002, 08:25 PM
Has anyone tried the new trim tool? What have you found?
I've found it a bit unstable. If I add one projection to a surface there is no problem. However, add a second and things start going a bit odd......the surface does not conform to the boundary curves or the trim curve.
And if a third curve is added, then it locks up my pc.
I may well be the way I'm adding the curves but I appear to be following the notes in the help menu.
Regards,
Alan.
I've found it a bit unstable. If I add one projection to a surface there is no problem. However, add a second and things start going a bit odd......the surface does not conform to the boundary curves or the trim curve.
And if a third curve is added, then it locks up my pc.
I may well be the way I'm adding the curves but I appear to be following the notes in the help menu.
Regards,
Alan.