CGTalk - Awkward Moments -Bank Machine *Raptor235*

View Full Version : Awkward Moments -Bank Machine *Raptor235*

Raptor235

11-07-2002, 12:09 AM

I hope this goes well here is the basic summary of what I want to do....

Joe walks up to the machine
Joe puts a card in the machine, the machine rejects it.
Joe scratches his head and tries again, the machine shakes from side to side and then spits out the card at him
Joe bangs on the machine, a big arm comes out with a hammer and hits him on the head
Joe calls in a tank
Just before the tanks shoots at the machine the big arm grabs job by the head and plugs his head into the turret and it explodes
Joe stands there with a sign "Will animate for money"

that's it let me know what you guys think these are some rough sketches I'm still workin on the character I'll animate low res parts for the character and after the challange substitute a high res body....ANY SUGGESTIONS ARE WELCOME BEFORE EVERYTHING IS SET IN STONE SO PLEASE LET ME KNOW IF YOU HAVE ANY OTHER IDES...thanks

Raptor235

11-07-2002, 12:11 AM

Small storyboard

stzaske

11-08-2002, 10:56 AM

Is this within the 15 second time limit? Just warning.

Raptor235

11-08-2002, 03:19 PM

Ya it might be a bit though I might cut something out....hehe I see you have the MY ANUS IS BLEEDING AVATAR hehehe that's a great piece of art :)

maelstrom

11-08-2002, 04:01 PM

you watch too many cartoons! ;) ;) ;) ;)

Raptor235

11-08-2002, 05:33 PM

heheh why is that??! :applause:

Raptor235

11-10-2002, 10:35 PM

I went through and got rid of a couple of steps and tightened it up so here is the final cut.

Run up to the machine - 1 sec
Put card in, machine shakes and spits it out - 3 sec
Hit Machine, machine hits Joe on the head - 3 sec
Black Screen - 0.5 sec
Call tank in - 2 sec
Machine grabs Joes head and puts it in the turret, shot fired - 3 sec
Black Screen - 0.5 sec
Joe Standing with a sign.

That's it

CGTalk Moderation

01-13-2006, 09:00 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.