PDA

View Full Version : Skin stopped working

Arvetis
09-07-2005, 06:49 AM
This is probably something completely obvious that I'm missing because it's 3 AM, but I've been staring at this thing all night and my brain has shut down. Skin just stopped working. I move the biped, the skin mesh doesn't move. The envelopes are all set up, the mesh isn't frozen, but I get nothing. What's going on?
LoneRobot
09-07-2005, 08:52 AM
have you enabled the subobject mode on your mesh accidentaly?
PEN
09-07-2005, 12:44 PM
Or are you at Frame 0 and you have turned off Always Deform?

Is the Modifier turned off in the stack?

Are you far more tired then you think and you are actualy sitting naked in the lobby of your appartment stairing at the security monitor and you can hear faint voices in the back ground saying "I think he is sleep walking, what is he saying about his skin not working, well it isn't working for me either! Better just leave him alone"
Arvetis
09-07-2005, 04:25 PM
It was, of course, that I had edges selection mode on for the mesh, and didn't notice because I had edged faces turned off.

Sorry, I promise never to post before getting a good night's sleep again.
LoneRobot
09-07-2005, 04:29 PM
Are you far more tired then you think and you are actualy sitting naked in the lobby of your appartment stairing at the security monitor and you can hear faint voices in the back ground saying "I think he is sleep walking, what is he saying about his skin not working, well it isn't working for me either! Better just leave him alone"

i have the same dream...:)
CGTalk Moderation
09-07-2005, 04:29 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.