AlanMc
11-05-2002, 12:18 AM
Dear all,
Once an assembled, single surface has been created from two surfaces there is still a noticeable interface. How can this be removed to show a smooth transition. (the two surfaces were boundary snapped before the creation of the single surface with only small shift in their respective positions)
I have adjusted settings in the SCM and this has helped, but the interface can still be seen, slight though it may be.
Any help would be appreciated.
Regards,
Alan.
Once an assembled, single surface has been created from two surfaces there is still a noticeable interface. How can this be removed to show a smooth transition. (the two surfaces were boundary snapped before the creation of the single surface with only small shift in their respective positions)
I have adjusted settings in the SCM and this has helped, but the interface can still be seen, slight though it may be.
Any help would be appreciated.
Regards,
Alan.