CGTalk - extrude

View Full Version : extrude

doddy

11-01-2002, 02:15 PM

Hi,

I am a newbie and trying to model a head. My head uses symmetry so that I only need to modify half the model. I am trying to extrude multiply slected polygons. How can I stop the extrusion having the effect shown in the picture?

i.e. Extrude in a certain direction.

Any help appreciated
Thanks
Doddy

gnarlycranium

11-02-2002, 03:42 AM

There are only a few different options for the direction things get extruded in-- somewhere below the command in the panel you'll find an 'extrude by' option... I think Group and Local Normals are your options. Either way, you probably will still get the problem you're having here-- just tug those faces over to the side so the neck matches up in the middle, it's not too hard.

doddy

11-02-2002, 04:55 AM

Thanks for the reply!

I will do it the manual way :p

Cheers

CGTalk Moderation

01-13-2006, 08:01 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.