CGTalk - Birail and Isoparms

Masnado

07-07-2005, 03:34 PM

Hi everyone.
I'm a newbie and so I have many doubts.
Here is one:

I've noticed in some tutorials that surfaces derived from birail tool (2) get more isoparms parallel to rail curves than what I get (i.e. no horizontal isoparm againt 6 or more in tutorials).
Is there a way to achieve this result?
I've tried to find a solution also in attribute editor (render stats) and in the display mode but unsuccessfully :sad:

Thank you for any answer.

Six60Sicks

07-07-2005, 07:46 PM

I am having a bit of trouble understanding your question. If your resulting surface (after using any NURBS tool) is not broken up the way you want, then simply rebuild the surface or add isoparms. I hope this helps. If not please try to formulate your question more clearly if possible.

CGTalk Moderation

07-07-2005, 07:46 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.