PDA

View Full Version : (silly) NURBS QUESTION

AXE
10-23-2002, 08:45 PM
hey guys,

I'm a newbie to NURBs modelling, so please forgive me for the silly question but...how do I attach these 2 nurbs surfaces?

I've tried to use the Attach Surfaces tool, but it makes disappear the two surfaces...so I thought there was something wrong and played a little with the tool settings...but the result did not change. I guess it's quite simple...it's just a nurbs surface generated by a loft and half a nurbs sphere that I need to make join together.

Any suggestion to attach good and seamlessly surfaces together?

tnx,

AXE
gmask
10-24-2002, 03:01 AM
One way to handle this is mak emore isopamrs and then dettach the ones close to the edges yu need to attach. Then after attaching those near edges you can attach everythign and it shoul ddeform less than you are currently getting.
AXE
10-24-2002, 12:24 PM
ok, thanks for the tip. I'll give it a try.

AXE
CGTalk Moderation
01-13-2006, 07:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.