CGTalk - Component Editor Empty?!!!

View Full Version : Component Editor Empty?!!!

Axercise

06-28-2005, 06:46 PM

I'm stumped. I'm using Maya 6.0.1... i'm skinning and rigging... everything seems fine... then suddenly i'll go into the component editor to fine tune weights and low and behold... the influence list on the left side is present, but in the editor window there are absolutely NO weights being displayed for any selected vertice. It's not that they're all zero across the board... it's that the ONLY column visible is the "Total" column... which registers all weights as ZERO. This is very odd. I've gone back to a previous saved version where i'm ABLE to see all the weights in component editor, started working on THAT... and before i know it i check the component editor sometime later and PRESTO, same problem all over again! What is going on? Does ANYone know about a fix, or is something i should be avoiding?

Please and thank you,

Wes

ShiroiOokami

07-13-2005, 01:01 AM

I had a problem similiar to this where the component editor wouldn't display any values, just let me switch between the above tabs. Saving and reloading maya fixed it for me....I have yet to run into the problem again though.

CGTalk Moderation

07-13-2005, 01:01 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.