PDA

View Full Version : problems with surface

bloddy_newbee
10-21-2002, 07:59 PM
I wanna create a text and surface the front with surface>planar,
I get always bad results with an brocken surface. Very unpleasant. I've tryed
to increade the tesselation but there havn't been a lot.

If you don't know, what I mean, I attached a .jpg.

What can I do?
wedge
10-21-2002, 08:03 PM
what kind of surface is it?
bloddy_newbee
10-21-2002, 08:16 PM
I create a letter "O" under create>text, beveled the spline and mark the front isoparm of it, went under surfaces>planar and type:

Degree : Linear
Curve Range : Partial
Output Geometry : Nurbs
DesignDawg
10-21-2002, 08:30 PM
You need the BevelPlus plugin from A|W. You'll never go back to creating text the old way again.

Ricky
CGTalk Moderation
01-13-2006, 07:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.