PDA

View Full Version : Transparency jumps

scrimski
06-14-2005, 03:45 PM
Got a problem:
When blending two layers by setting down the transparency of the top layer I have visible jumps in the layers tranpsarency when I go below an transparency amount of 20%. Above these 20 % it seems to work as it has to, but below this amount, the layer just totally disapears. I tried various blending modes for the top layer, but it didn't fixed the problem. Any ideas or workarounds?

Thanx in advance.
Mylenium
06-14-2005, 05:23 PM
Got a problem:
When blending two layers by setting down the transparency of the top layer I have visible jumps in the layers tranpsarency when I go below an transparency amount of 20%. Above these 20 % it seems to work as it has to, but below this amount, the layer just totally disapears. I tried various blending modes for the top layer, but it didn't fixed the problem. Any ideas or workarounds?

Thanx in advance.

Transparency is calculated based on on an inverse multiply formula, not linear. Use the Channel -> Blend effect to get a linear dissolve.

Mylenium
scrimski
06-14-2005, 05:32 PM
Dankeschön
CGTalk Moderation
06-14-2005, 05:32 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.