PDA

View Full Version : Pyro-Z redesign (CAR)


EighthDecay
12-18-2001, 08:46 PM
I decided to model a new car again,, i just love modeling them,, as you know... and I looked at my old design called the Pyro,, and thought I should try modeling that way again.. I started with a Sphere,, gave it a UV of 8x8
with the Apex's at the rear and front of the car,, I then just started squaring off the bottom and added points where needed,, After I got my final shape, I cut the wheel opeings out. added a little trim to them. then did the same to the res of the car. Just went around and seperated pannels with 2 offset curves to get the pannel gap's.

Pretty quick model. I made it in about 3 hours total,, and about 1 hour to get the main shape out of the Sphere.

I'm gonna add a spoiler that will follow the long lip on the rear. it might make it look a bit bigger in the rear.

Modeled in RHINO3D and Rendered in MAX4

http://www.eighthdecaydump.f2s.com/images/cars/PyrOZ-GT-Layout1.jpg

CGTalk Moderation
01-13-2006, 01:26 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.