PDA

View Full Version : Origami


Rooka
08-28-2002, 06:41 AM
Hello!

Has anybody modelled yet an origami figure?
How did you proceed or how would you proceed?

Rooka

Grey
08-28-2002, 02:00 PM
get an origami book, and start with a sinle polygon.

Knife the polygon anywhere htere's a fold on the paper and fold that polygon thus in Ponts mode.

The only thing is, I'd probably do this in rhino as I have 3DRotate on any definable axis, including the fold points.

CGTalk Moderation
01-13-2006, 03:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.