Matariki
10-10-2004, 08:22 AM
Hi wizards,
I just started 3D modeling when I got my copy of Modo, excused therefore if this has been covered or has a trivial solution. I beveled the 12 polygons and pulled them out a bit. Now I want to put them all at an angle of about 20 degrees. I switched to local action center and started to rotate the polys. However only 8 of the 12 polys rotate downwards while 4 rotate upwards. The 4 are distributed randomly it seems. What did I miss or made wrong?
I am somehow unable to post an image and have therefore linked it.
picture (http://homepage.mac.com/drmapl/modo/index.html)
I just started 3D modeling when I got my copy of Modo, excused therefore if this has been covered or has a trivial solution. I beveled the 12 polygons and pulled them out a bit. Now I want to put them all at an angle of about 20 degrees. I switched to local action center and started to rotate the polys. However only 8 of the 12 polys rotate downwards while 4 rotate upwards. The 4 are distributed randomly it seems. What did I miss or made wrong?
I am somehow unable to post an image and have therefore linked it.
picture (http://homepage.mac.com/drmapl/modo/index.html)