CGTalk - Using the Round Tool for NURBS surfaces

View Full Version : Using the Round Tool for NURBS surfaces

stark-001

02-02-2002, 04:02 AM

ok i need some help with the round tool in maya

in the Manual its written:

Edit NURBS > Round Tool. You are prompted at the help line to select pairs of edges until you press Enter to perform the rounding.

My problem is ... Where can i Get " Edges " picked when im Working with NUBRS ???

:confused:

SheepFactory

02-02-2002, 06:08 AM

hold down right mouse button and select isoparm , than select the isoparm thats on the edge

hope that helps

A|i

stark-001

02-04-2002, 02:02 AM

i hear you Sheep Factory

but for some reason everytime i select my geometry ( lets say a cube ) i pick-mask my isoparm and the other adjacent isoparm and activate the Round tool

Maya gives the error " You must Select one Pair of surfaces Edges " .....

i tryed everything !!! cant seem to have a rounded Nurb cube

SheepFactory

02-04-2002, 02:23 AM

as it says you must select one edge at a time.

i made a quick test , it works fine for me .

can you post a screenshot and show us the problem?

Good Luck

A|i

CGTalk Moderation

01-13-2006, 12:39 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.