PDA

View Full Version : XSI: how to make "gaps" between car panels?


AzNightmare
06-09-2004, 04:47 AM
whats the best way to make the "gaps" between car panels in softimage: XSI?

this is for Hi res car model.
what i do now is grab the edge, duplicate (ctrl+d) and pull it in the car a bit, then duplicate again and pull it in. then it sorta makes a nice sharp edge. but it just doesnt look right...

StephanD
06-09-2004, 12:54 PM
I'm not sure what method you're using,but it really comes down to what the actual surface looks on close-up.

If there's a physically un-attached part,like panels,held by underhooks,then make them separate objects,it'll pay off to go as close as possible as the actual thing,from both a shading and manipulatability perspective.

Jb5k1
06-10-2004, 12:13 PM
just search the whole entire board for cars and junk

there are a few tutorials on here

u basically bevel a bunch and make sure a few edges are close together to define the shape when its smoothed

CGTalk Moderation
01-18-2006, 11:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.