kodinaarian
04-13-2004, 10:09 PM
Hi everyone
i want to keep this question software non-specific as possiible,
here goes :
when making a modeller demo reel, and showing off your poly wiremeshes, what should be the division lvl ? if i keep it at 2 then the mesh is too dense and doesnt show the topology well, but the rendered shaded geometry is at division lvl 2, so should i leave the wiremesh lvl at 2 too, and also is there a good way to render out wireframes,(maya). ??
i want to keep this question software non-specific as possiible,
here goes :
when making a modeller demo reel, and showing off your poly wiremeshes, what should be the division lvl ? if i keep it at 2 then the mesh is too dense and doesnt show the topology well, but the rendered shaded geometry is at division lvl 2, so should i leave the wiremesh lvl at 2 too, and also is there a good way to render out wireframes,(maya). ??