Grey
07-10-2002, 07:37 PM
Having trouble with snap settings.
I'm setting up lights and I have an imported spline curve which is not flat.
I need my lights to run along it's lentght exactly, and I'm having trouble.
I'm setting up intancing, copying each one as I go. But when I move the copy along the spline curve it wants to stay at the same hight it was and varies from the curve, though it's following it as if it were on a 2D plane.
How do I get it to stick to the curve?
I'm setting up lights and I have an imported spline curve which is not flat.
I need my lights to run along it's lentght exactly, and I'm having trouble.
I'm setting up intancing, copying each one as I go. But when I move the copy along the spline curve it wants to stay at the same hight it was and varies from the curve, though it's following it as if it were on a 2D plane.
How do I get it to stick to the curve?