PDA

View Full Version : Character: US troop wip


Tronno
11-20-2003, 10:09 PM
Hey there, this is my first post! I figure you're all pros here, while I'm just 17 and therefore not a very experienced modeler, but please bear with me.

As part of a school project, I'm modeling a generic low-poly grunt in MAX 5. Once the model is finished, I'll texture and animate it. At this point I've modeled most of the symmetrical parts of the character and I'm about to start modeling the asymetrical bits (equipment, etc.), which means I might have to permanently close the seam between the two halves of the model. But before I do that (and should I?) I could really use some crits on proportions, aesthetics, problems with the mesh, and anything else that stands out.

Anyway, without further ado, here it is - 2670 triangles, no seam:

http://home.primus.ca/~adba/images/fb.jpg
http://home.primus.ca/~adba/images/head.jpg
http://home.primus.ca/~adba/images/wire.jpg

Again, any crits would be appreciated.

CGTalk Moderation
01-16-2006, 05:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.