How to blur an emitter ?

[ondudengrund]

Im not sure if its this you are looking for but, if you connect your pEmitter1 node to a pRender1 node ( found in the particles tab, then you will have some blur and glow options in the pRender1 node.
heres a link for a quick set up (for Fusion 6)
Im not sure what to do if it should be 3d particles though.

http://www.fearfactory.dk/stuff/pEmitter_blur_setup.comp

http://www.fearfactory.dk/stuff/pEmitter_blur_setup.jpg

http://www.fearfactory.dk/stuff/pEmitter_blur_setup.jpg

[pingking]

for 3d particles you can render your particles and put a blur afterwards

or you can blur the image you feed into the emitter

[michaelaaut]

thank you, makes more sense now..
just one more thing... I tried to figure out where I can change the size of the points ?

I don't mean the size of the emitter itself, but it's particles ?

Can't find that attribute ....

[ondudengrund]

in the pEmitter1 node, go to the style tab and open the size controls, there you have it.

[CGTalk Moderation]

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.